resistor

The most common have four but they can range all the way up to 6 per resistor.

There are many different types of resistors you can find.

If we replace them by, instead of those we're just going to have one resistor.

Series - Where the resistors are linked one after another.

And so that's sort of the first thing to see is you have two resistors connected together.

To the power supply, the entire computer system looked like a simple resistor.

Due to their high price, these resistors are no longer used in most applications.

The line can therefore be matched with just a resistor at either end.

This is connected through a resistor to one leg of the line.

The other leg is connected through another resistor of the same value.

Resistors are where the power leaves the circuit, usually as heat.

By this approach, it is possible only to lower the value of the resulting resistor.

Some direct current designs also used them as starting resistors.

It is the way I obtain most of my resistors incidentally.

One or more resistors are removed to increase the voltage.

So that we have a circuit formed just with two resistors in series.

Maybe I needed to make a resistor, or a capacitor.

The human body is not much of a resistor.

The current in each individual resistor is found by Ohm's law.

This will waste power in the resistors, and generate heat.

These two resistors should stand 3mm clear of the board.

Resistors are used to limit the current when the motor starts.

As these resistors are in series, the voltage drops will add.

By adjusting the resistor, you control the frequencies that are cut out.

Quite often this resistor is already part of the voltmeter.