non-inductive resistor

Should be a 100 Ohms metal film or other non-inductive resistor.

Both inductive and non-inductive resistors are available.

The end of the wires meeting at the opposite vertex is either left open (unconnected), or terminated with a non-inductive resistor.

R2 provides the desired longitudinal impedance using 90 Ohms or 500 Ohms metal film or other non-inductive resistor.

Terminated in the middle of the upper conductor with a 400- or 480-Ohm non-inductive resistor, rated to safely absorb at least 1/3 of the applied transmitter power.

A non-inductive resistor approximately equal to the characteristic impedance of the wire, about 400 to 600 ohms, is connected from the far end of the wire to a ground rod.