v-belt technical

Pay particular attention to the smaller V-belt that drives the fan.

I popped the v-belt off the pulley and the engine continued running.

They commonly have direct drive (no v-belt or pulleys) from a universal motor.

Drive mechanisms can be a single v-belt, a serpentine belt or multiple v-belts.

Its automatic dry centrifugal clutch is driven by V-belt.

Pneumatic tube, high and low pressure hose, cable sheathing round belt, V-belt.

The dynamo had been switched to the left hand side and was now driven by an additional v-belt from the fan pulley.

The transmission is a double-cog V-belt constantly variable automatic transmission.

In a later stage of development, the V-belt was reintroduced for the alternator, so that the battery would be charged even at low engine speeds.

This is known as a multiple-V-belt drive (or sometimes a "classical V-belt drive").

Air blower drive: V-belt, crankshaft to generator shaft.

A CVT works on the principle of two cone-shaped pulleys and a V-belt.

Comments: This article is intended to provide maintenance personnel with a standardised procedure for correctly installing a V-belt and the sheaves in which they operate.

An automatic clutch with a variable-speed V-belt transmission eliminates clutching and shifting and provides smooth acceleration, so your always in the right gear.

Block Unit: For V-belt and direct drive for OEM applications.

That same year, John Gates, Charles's brother, developed a belt made of rubber and woven threading called a V-belt, due to its shape.

Charles' uncle John Gates invented the V-belt in 1917, a staple component in all modern automotive and industrial applications.

BHP Billiton Steel rolls with efficient v-belt drives (118k)

Plant drives Ensure appropriate drive is used (i.e. direct drive, v-belt, notched belt, flat belt, etc.)

DRIVE: Multigrip, poly V-belt provides the direct speed reduction between motor and peeling disc.

The motor was a rear-mounted twin cylinder air-cooled 50cc engine from Motobécane which powered the rear wheel via a V-belt and chain linkage.

The endless rubber V-belt was developed in 1917 by John Gates of the Gates Rubber Company.

Auxiliary V-belt drive pulley may be attached opposite saw end of arbor to operate Lathe or Boring Table attachments listed at right.

Belt (V-belt, Synchronous belt, Flat belt)

The V-belt needs to be very stiff in the pulley's axial direction in order to make only short radial movements while sliding in and out of the pulleys.