try square

Use the ruler to mark off the individual pieces, then draw straight lines across the face of the board with the try square.

Invest in a try square too, so you can make sure your saw cuts are absolutely square.

A wood scribe is often used with a try square for accurate scribing.

Use a try square to rule lines horizontally.

The try square has a fixed metal blade, usually six inches long, and a wood handle at an exact right angle.

A try square is a woodworking or a metal working tool used for marking and measuring a piece of wood.

The top inside corner of the handle on some try squares is cut off at a 45-degree angle, for marking miter cuts.

To cut the slots I used a razor saw, held against a try square butted up to the batten.

A traditional try square has a broad blade made of steel that is riveted to a wooden handle or 'stock'.

Try square' is so called because it is used to "try" the squareness.

Hold a try square tight against the wood and scribe across with a sharp trimming knife at the marked point.

A B Use the Try Square to get the right angle lines to the edge.

Insert the points and press the board together, using the try square to check that the drilled board is square.

My tools were a hammer, a handsaw, a try square, a tape measure, a level and a length of Manila rope.

Have you ever tried Square or Round Dancing?

The sides and back must have square ends, so mark the cutting line carefully with a try square and pencil.

Lay the timber on a flat surface then square off the taped-together ends using a try square and marking knife.

Modern try squares may be all-metal, with stocks that are either die-cast or extruded. '

A machinist square or engineer's square is the metalworkers' equivalent of a try square.

Try Square, Rule and a Pencil.

Three types of squares are useful: Try squares, framing squares and combination squares.

The Speed Square combines some of the most common functions of the combination square, try square, and framing square into one.

Our Try Square level is not only a try square, but also a rule, a spirit level and an angle finder.

The unsurpassed quality try square is crafted from Rose She-Oak (Casuarina Torulosa) and high quality Australian brass.

When you are satisfied the measurement is correct take your try square in one hand, the pencil in the other and place the pencil in the prick point you have made.