supply voltage

They are also common in cars, where the 12V supply voltage means that just about everything needs a large amount of current.

Now consider a differential system with the same supply voltage.

The boost of the supply voltage is shown for a real music signal.

This means that approximately 2% of the supplied voltage is lost in the wire itself.

The resulting integrated circuit runs off a single power supply voltage.

The power supply voltage changes will appear in the input stage as positive feedback.

Generally, supply voltages must be within 5% of their nominal values at all times.

Imagine that the emitter supply voltage is turned down to zero.

Incandescent lamps are very sensitive to changes in the supply voltage.

The trend towards lower supply voltage therefore works against the goal of high clock speed.

Furthermore, the charging time is inverse-square to its supply voltage.

The little-used negative supply voltages, however, have a 10% tolerance.

The collector current does not remain constant with variation in temperature or power supply voltage.

In the bilevel drive there are two supply voltages.

Voltage scaling: lower supply voltages use less power, but go slower.

There are not different chips for different logic supply voltages.

A large supply voltage and phase resistance are only required when the motor is operating at high speeds.

This often matches conventional current direction, because in many circuits the power supply voltage is positive with respect to ground.

To see why, consider a single-ended digital system with supply voltage .

Line (also known as phase or hot) carries the full supply voltage relative to the neutral (and to earth).

To offset this effect and maintain normal operation, the supply voltage is gradually lowered.

The current is now opposed by the supply voltage and is rapidly forced to zero.

It allows processors with different supply voltage to be mounted on the same motherboard.

More recently, wider beam versions are available designed for direct use on supply voltages of 120 or 230 V.

How can the supply voltage and consequently the phase current - be increased during acceleration or deceleration?