seacock

The only thing left to try was to get the tube off the seacock from the inside.

If the seacock is open, water may flood the boat.

Attached to it were half a dozen smaller pipes, each with its own seacock.

Smaller pipes branched off the sides of the larger one, each with its own seacock.

He closed the seacock, selected the proper and went to work on the six bolts holding the flanges together.

Apparently the seacock valve and other metal parts were scavenged for their scrap value.

A Kingston valve is a type of seacock.

In a raw water system the water is drawn up through the seacock by the water pump.

Inline filter with bronze skin fitting and all SS seacock.

"A seacock on each side of the engine room," the skipper replied, indicating a large valve operated by a wheel.

She floated and could dive by opening the seacock and filling the ballast tanks.

Pulling the seacock means opening the valve between hull bottom and sea, and results in scuttling the ship.

They were symmetrical top-to-bottom and side to side; a seacock could be opened to fill one side with water.

I remove the water intake hose from the seacock, stick it in the antifreeze and pump a quart or two into the holding tank.

When you are making up the connection ensure that you don't rotate the seacock as you tighten the nuts.

Emergency seal for inlet/seacock failure.

In case a hose parts and you can't operate the shut-off you can put the bung in the seacock to stop the water flow.

Where you can discharge overboard, a simple diverter valve after the pump, allows you to select either holding tank or seacock.

This will arise either through a drain blockage or the hose detaching from the spigot or seacock.

There is a general consensus of opinion that a hull anode should be fitted and wired to the engine and the cooling water inlet seacock.

Q Pump hard to operate A Seacock may be closed - Open; Pump/pipe blocked - Remove front cover and clean.

Other components of the cooling system, whether it be raw water or enclosed, are the seacock, sea strainer, hoses and clamps, belts and water pump impeller.

As a backup safety measure you should have a soft, tapered, wooden plug (called a bung) of the size of the seacock tied to the seacock.

He set down the bag, out the socket wrench kit, and went to theaearest The valve was joined to the cooling water by two fiangesone on the seacock and one on pipe.

Q Seacock Seizes A Lack of grease in conical plug - plug could need re-grinding with medium grinding paste (this forms a rough enough surface to hold the grease).