peripheral speed technical
cutting speed

In cases where the peripheral speed is high straight face blades are preferred over curved blades.

A single stage utilizing a large pressure drop will have an impractically high peripheral speed of its rotor.

The relative velocity of the flow and the peripheral speed of the rotor are w and u respectively.

Cone clutches are generally now only used in low peripheral speed applications although they were once common in automobiles and other combustion engine transmissions.

Gas turbine engines are designed with peripheral speeds as high as 400 m/s, and have operated reliably on thousands of aircraft over the past 50 years.

This type of generator featured rotor mounted windings which limited the peripheral speed of the rotor due to the centrifugal forces on these windings.

The excitation and AC windings are both mounted on the stator, the rotor is therefore a compact solid construction which can be rotated at higher peripheral speeds than the standard AC generator above thus allowing it to be greater in diameter for a given RPM.

The primary motion is accomplished at a certain cutting speed.

In those machines, cutting speed is regulated through the feed rate.

The fluids can increase tool life, cutting speeds, and the quality of the finished surface.

It can be prevented by increasing cutting speeds and using lubricant.

Avoiding burning is a question of using sharp bits and the appropriate cutting speed.

Measures include cutting speed and downforce on the cars, with more protection for drivers.

Extra care should be taken to choose the appropriate number of teeth, saw blade type, cutting speed and feed rate.

This somewhat offsets the tool wear from increased cutting speeds.

Part of the apparatus on the sarcophagus shows a gear train which could control cutting speed.

He also found that if a stream of water was used as a cutting fluid the cutting speed could be increased 30%.

"Potemkin cutting speed too," observed the acting science officer.

Maximum blade cutting speeds are controlled by a dial set into the trigger switch.

Proper lubrication and cutting speed will increase cutting blade life.

Generally cutting speeds are lower for hard materials, higher for soft materials.

As a wheel wears it will decrease in diameter, and its effective cutting speed will be reduced.

Cutting speeds are lower in roughing than in finishing.

Another benefit of lubrication includes higher cutting speeds.

But once in the air Tau pointed the nose of the flitter down valley, cutting speed to just enough to keep them airborne.

Angled gears provide 20% more cutting speed, greater torque and power to the cutting blades.

Factors affecting the calculation of cutting speed are:

The reduced friction would lessen the force necessary to cut an object, extend tool life, and possibly allow increased cutting speeds.

Its most common use is in the measurement of cutting speed (surface speed) in machining.

It vibrated angrily in his hand as the serrated edges of its blades accelerated up to their maximum cutting speed.

She forced leaden hands to controls, cutting speed and Gs so fast she almost retched.

Cutting speed and wire temperature combine to determine the thickness and consistency of kerf.