liquid injection

The method of liquid injection at the venturi throat can also cause problems.

Anti-psychotic drugs are taken daily in tablet form or liquid injection.

The critical components of a liquid injection molding machine include:

With direct liquid injection systems, increasing flow rate leads to incomplete vaporization.

• liquid injection systems for fertilizer - research?

Ensco Environmental Services has also two liquid injection systems.

Some of the established incineration technologies are: 1. Liquid injection incineration; 2.

In order for the liquid injection molding process to fully occur, several mechanical components must be in place.

This allows the controlled liquid injection of Autogas, resulting in better performance and more optimal combustion.

These boilers, fired by oil, coal or natural gas, often approach the time and temperature regimes of liquid injection incinerators.

Sludges can be disposed of by liquid injection to land or by disposal in a landfill.

However the use of liquid injection for additional cooling can generally overcome this issue in most hermetic motor compressors.

Seven of the destruction systems utilize liquid injection incinerators and one system uses a standard aluminum melting furnace.

Both must be constructed of wear-resistant materials because of the high liquid injection rates and nozzle pressures.

Liquid injection systems use special tanks with circulation pumps and return lines similar to petrol fuel injection systems.

The gases from the rotary kiln are passed into a second incineration zone, which is typically a liquid injection incinerator.

None of the liquid injection units was originally designed for PCB destruction and all have been modified as required.

A novel, single, fixed nozzle with liquid injection thrust vector control on a larger second-stage motor to increase missile range.

Commercial hazardous waste incinerators are usually a combination of liquid injection and rotary kiln incinerators.

The MWP100 system is a second generation liquid injection unit based on the design and experience with the MWP75.

For very high volume systems (and for some smaller volume systems), liquid injection odorizers are being manufactured.

Since 1990, rates of liquid injection and extraction, as well as gas produced, remained fairly constant in all three oil and gas fields.

The most widely used incinerators are the rotary kiln, fluidized bed reactor, liquid injection combustor and infrared incinerator.

The effectiveness of liquid injection damp proofing products is dependent on the type of formulation and the skill of the installer.

This figure is based on the assumption that design concept is for a rotary kiln incinerator followed by a liquid injection incineration after-burner.