Weitere Beispiele werden automatisch zu den Stichwörtern zugeordnet - wir garantieren ihre Korrektheit nicht.
In contrast, wire-wound resistors have the least amount of flicker noise.
Unfortunately, these instruments do not operate at frequencies low enough to fully measure flicker noise.
This can be due to thermal noise and flicker noise of the devices.
The NET of flicker noise limited detectors can not be reduced by increased integration time.
Flicker noise, electrical noise with a 1/f spectrum.
Flicker noise is a type of electronic noise with a 1/f, or pink power spectral density.
This filtering of DC also attenuates the flicker noise.
This design eliminates rubidium depletion as a failure mechanism and provides better temperature control without excess flicker noise.
In this paper, a new on-wafer flicker noise characterization system, well suited for technology characterization, is presented. 4:25 p.m.
In electronics, white noise will be stronger than pink noise (flicker noise) above some corner frequency.
Oscillator phase noise often includes low frequency flicker noise and may include white noise.
The effect of flicker noise can be reduced with negative feedback that linearizes the transfer function (for example, emitter degeneration).
Rane Pro Audio Reference definition of "flicker noise"
Aldert van der Ziel was a pioneering researcher into the phenomenon of flicker noise in physical electronics.
At very low frequencies, you can think of the noise as becoming drift, although the mechanisms causing drift are usually distinct from flicker noise.
The term flicker noise is sometimes used to refer to pink noise, although this is more properly applied only to its occurrence in electronic devices.
There will also be flicker noise caused by electron transit through amplification devices, which is reduced using heterodyne amplification.
Flicker noise is electronic noise with a 1/ƒ frequency spectrum; as f increases, the noise decreases.
In an analog system, other natural analog noise sources exist, such as flicker noise and imperfections in the recording medium.
Like other electronic devices, LDOs are affected by thermal noise, bipolar shot noise, and flicker noise.
In general, electronics that digitize an analog signal suffer from several noise sources such as thermal noise, flicker noise, and shot noise.
In analog circuits, designers are also concerned with noise that arise from physical sources, such as thermal noise, flicker noise, and shot noise.
In addition, shot noise is often less significant as compared with two other noise sources in electronic circuits, flicker noise and Johnson-Nyquist noise.
Other important elements that determine the phase noise are the transistor's flicker noise (1/f noise), the output power level, and the loaded Q of the resonator.
For example, the detector can cancel the flicker noise which dominates in all microwave amplifiers, and in principle, can reduce the noise by a factor of 100,000.