epoxy adhesive
epoxy glue

Epoxy adhesives can be developed to suit almost any application.

I believe there are epoxy adhesives specifically formulated for metals.

This bar is retained in the hole with a high-strength epoxy adhesive.

Epoxy adhesives are better in heat and chemical resistance than other common adhesives.

A small, cleanly broken chip from the corner or edge of a step can usually be glued back on with epoxy adhesive.

Its mane was warmed up just enough for some new epoxy adhesive to bond with some very old stone.

High strength epoxy adhesives are used in fabrication of carbon fiber composite drive shafts for cars.

If a small corner of a step - less than two inches thick - breaks off, it usually can be glued back on with epoxy adhesive.

Although most adhesives come ready-mixed, some - like epoxy adhesives - must be mixed before use.

Unlike many other types of glues, an epoxy adhesive can fill gaps and even be molded into a structural part.

Some dispensing packages for two-part epoxy adhesives do more than passively contain the two components.

Epoxy Adhesive Formulations that use the compound.

"The only concession I'm making is in the use of modern epoxy adhesives instead of the white glue they used in the old days," he said.

Fusor epoxy adhesive and Versilok acrylic adhesive trademarks were adopted.

In general, epoxy adhesives cured with heat will be more heat- and chemical-resistant than those cured at room temperature.

Some "breakable" epoxy adhesives contain suspensions of AP.

The ceiling panel collapse has been attributed to the failure of bolts anchored into the structure with an epoxy adhesive from which the panels are hung.

For low-cost, low-powered applications, the die is often glued directly onto a substrate (such as a printed wiring board) using an epoxy adhesive.

Arctic Silver Thermal Adhesive is a silver-based dual component epoxy adhesive.

The company has developed epoxy adhesives for the spot-bonding of tile or natural stone products as the façade of new or existing buildings.

A generation of thin-sets, which are lighter, epoxy adhesives developed in the 1950's, has largely replaced mud-sets, with equal effectiveness, Mr. Spretnjak said.

In the air ionization process, air is forced through a 2-inch-long capsule to whose inner surface tiny beads or "microspheres" of polonium-210 have been attached with epoxy adhesive.

The product J-B WELD is a two-part epoxy adhesive (or filler) that can withstand high-temperature environments.

By covering floating substrates like woodchips with epoxy adhesives, water logging can be prevented and TiO particles can stick to the substrates.

A chipped tile that is not loose can be restored by cleaning the chipped area and filling it with grout or epoxy adhesive, but the repair may be unsightly.