emery cloth

Start by cleaning the end of the pipe carefully with the emery cloth.

Smooth the rough edges, using emery cloth or a file.

"Then use a very fine emery cloth - No. 320 or 220 - to smooth out any scratches."

Do not use emery cloth for polishing electrical components, such as contact points.

Then use the emery cloth to polish the outer surface of each pipe until they shine.

As a finishing step, wrap the file in emery cloth to polish the side edges.

Harveygave the core a final polish with an emery cloth.

One other type of sandpaper deserves mention: emery cloth.

It was no more than half an inch long, and had been roughened with emery cloth to make a good electrical contact.

Some works from the mid-1980's are small paintings done on emery cloth, a rough dusky material.

Using fine-grit emery cloth or steel wool, polish the surfaces that will come in contact.

Finally, smooth the cut edges with emery cloth or a carbide-grit rod, a type of saw blade.

I was about ready to start polishing on the barrel with fine-grade emery cloth when Betty called me from the back door.

Sandpaper and emery cloth are coated abrasives for hand use, usually non-precision.

After filing, wrap the tool in emery cloth and draw it back and forth across to polish the work surface.

Next, polish with emery cloth the inside of each valve where the valve will fit over the end of the pipe.

Then use emery cloth to polish the ends of the pipes and the inner surfaces of fittings that will cover them.

First, remove any deep scratches with fine emery cloth or by rubbing them with a paste made of pumice powder and water.

Remove rust and dirt from the pivot hole with a small wire brush or fine emery cloth rolled into a cylinder.

Wire brush, wire wool and emery cloth are commonly used to prepare plumbing joints for connection.

When finished, the freshly cut edge of the tile can be smoothed by using emery cloth or a carbide-grit rod designed for sawing.

She snatched the lamp from his hand and rubbed it as if she was sorry she wasn't holding a handful of emery cloth.

Most racers advocate buffing the axles with an emery cloth to shave off any burrs that could slow the cars.

Emery cloth is a type of coated abrasive that has emery glued to a cloth backing.

To solder, start by polishing the surfaces to be joined by rubbing them with fine-grit emery cloth or steel wool until they shine.