desiccant

It is used as a desiccant for drying air streams.

Used as a desiccant, it works by a process called adsorption.

A desiccant is added to the dish to dry up the solution.

Once the desiccant is full, the fan is turned off.

Because of this, they often function as a desiccant.

A separate compartment inside the can contains a desiccant and a liquid.

Salt is a natural desiccant, which means that it draws and holds moisture.

The desiccant is then warmed to condense the water it contains.

The material can also be used as a desiccant and as a hydrogen source.

It is used as a desiccant, a catalyst, and as fertilizer.

The method generally, though not always, involves stirring the solvent with the desiccant.

It is the opposite of a desiccant, whose purpose is to keep things dry.

The desiccant is placed directly in the fan's flow path so it can absorb water from the air.

The anhydrous form is strongly hygroscopic, and can be used as a desiccant.

A desiccant, calcium chloride, is put into a cup.

After sprinkling the letter with alchemical desiccant, he looked back at Locke.

It was dried using a desiccant, a sugar called trehalose.

When however, the desiccant is soluble, the speed of drying is much higher.

Keeping your hearing aids in a closed container with a desiccant has a more subtle beneficial effect.

Drying tubes are often prepared in advance and the desiccant can be replaced when exhausted.

If the alumina desiccant is heated to 200 C, it will release the trapped water.

Just before drinking, a tab is pulled so that the desiccant comes into contact with the liquid and dissolves.

The air is dried to a dew point of -80 C by passing the air through a very strong desiccant.

Sodium chlorate is also used as a defoliant and desiccant for:

It is also used to pre-dry solvents prior to the use of a more reactive desiccant.

Neither utility has seen the new desiccant work, however.

The same type of trap holder is used as for the desiccant traps.

"We're very optimistic about supporting desiccant technology," he said.

Preheating of the air is shown to greatly enhance desiccant regeneration.

The regeneration of the desiccant vessel can be during three different methods:

Alternatively, a desiccant herbicide should be applied 10 days prior to cultivation.

For the injection molding press,a desiccant hopper dryer is recommended.

This is done with a rotating wheel either containing a desiccant material or permeable plates.

Some of these locomotives had never been used and still had the desiccant bags stuffed in the control cabinets.

This desiccant material attracts the water from the compressed air via adsorbtion.

There appeared to be some slotted pouches built in the case that contained desiccant to absorb moisture.

Desiccant water generators use less energy than cooling condensation water generators, which makes them a technology to watch.

Other variants include enthalpy wheels and desiccant wheels.

Processes such as desiccant cooling, evaporative cooling, and other innovative solutions exist for various end uses.

Liquid desiccant cooling allows to generate remotely and efficiently a moisture absorbing liquid.

As the water clings to the desiccant, the desiccant "bed" becomes saturated.

Light Impressions also sells a desiccant canister filled with silica gel, which absorbs moisture ($5.25).

These desiccant salts absorb moisture from the air, and equipment then extracts the moisture from the salt.

Kramer then eats some free chips the store gives out to its customers and unknowingly drops one of the desiccant packs in the salsa dip.

The labor for frequent replacement of desiccant dryers, permeation components, and the sensor heads greatly increase the operational costs.

Finally, the cool dry air leaving the desiccant bed is re-heated in a process heater and sent back through the same processes in a closed loop.

One form of wet desiccant water generation involves the use of salt in a concentrated brine solution to absorb the ambient humidity.

The system uses a rotating "wheel" that consists of an aluminum framework coated with a "molecular-sieve" desiccant material, which attracts water vapor.

The 'Lo' port, you leave open to the atmosphere (open air, or possibly through a buffer or desiccant chamber).

A desiccant dryer capable of maintaining a dew point of -40 F (-40 C) is recommended.