cooling fins

Higher than that and we could short out the cooling fins on top.

The third type was thick wall the way down from the cooling fins to the bottom.

If you look at the picture, you'll see where I easily wiped away a lot of cooling fins.

The barrel also received cooling fins along its entire length.

The first five were produced without cooling fins on the crankcase.

The laser mirror was small but massive, with its heavy cooling fins at the back.

The cooling fins at the back of the food compartment must not have items such as cans pressed up against them.

The twin cylinders have 'cooling fins', but they are almost entirely for show.

Heat transfer to air can be aided by incorporating cooling fins onto the drum.

Use of cooling fins on profiles greatly increases the heat dissipation area.

Those are cooling fins so those batteries won't overheat in use.

This is the "engine as power supply" and it even seems to wear the cooling fins of an electronic component.

An aluminum sump with cooling fins is an unusual feature of this engine.

These larger cooling fins was also added to the post-1953 D1 models, albeit they maintained their smaller bore.

Shine a flashlight through the coils to see if there is dirt on the inside and to check the cooling fins.

It is normal to accumulate frost on the right side of the bank of cooling fins.

A Pentium chip operates at a power of about 20 watt and needs cooling fins.

Initially cooling fins were machined for extra heat transfer but this was found to be unnecessary.

Motor framed with radiate cooling fins, permits 40% continuous rate.

The gun was designed with a long barrel (305mm) which featured a compensator and cooling fins.

Clean the cooling fins, fan blades and blower housing.

Finally examine the cooling fins on the condenser coils.

These big bits are cooling fins, see?

For one thing, the device has a built-in 1400-watt amplifier, which would normally produce a lot of heat and require big cooling fins.

The aluminium cooling fins inside were in two pieces and once the shroud was removed, came loose from the barrel.