bleed valve

In the plumbing for each engine, there is a fuel, or hydrogen, bleed valve.

For a moment he considered going to the lower level to the oxygen bottles and opening up the bleed valve, then dismissed the idea.

No bleed valves or tiny orifices slowing down stroke time.

The adjuster controls a bleed valve to bypass the cartridge.

To bleed a radiator, first position a pan under the bleed valve.

This smells like rotten eggs and will ignite if you hold a flame next to the bleed valve.

In steam systems, individual radiators are usually equipped with a thermostatic bleed valve.

Place a pan under the radiator bleed valve and open it with a radiator key.

The manual bleed valve is located next to the air hose and air inflation gauge.

The manual bleed valve allows the manual release of air pressure from tire.

Small, simple needle valves are often used as bleed valves in hot water heating applications.

There are several advantages in using a Double Block and Bleed Valve.

That valve is probably the bleed valve for getting rid of air bubbles when the system is charged up.

The fuze works on an air pressure system, with the top pressure plate forcing air through a small bleed valve.

Cursing, he stayed long enough to damp the fire and open a bleed valve so the boiler wouldn't blow up while he was away.

To release it, wait until the radiator is operating fully, then loosen the bleed valve, on the end opposite the inlet valve.

Worn or contaminated compressor components such as eroded rotor blades, seals or bleed valves.

He flipped the bleed valve open and scrambled back toward the overturned gravsled as the red viral spray hissed against the dome's skin.

Both propellant bleed valves were mounted to the bootstrap lines adjacent to their respective turbopump discharge flanges.

The convenient bleed valve makes it easy to drop the pressure if you overinflate. . . . . .

Fuel injection systems, aluminum fuel filters, brake pins and bleed valves are just a few applications that take full advantage of the deposit's corrosion resistance.

The air pressure system consists of 4 components: air hose, air inflation gauge, inflation pedal and manual pressure bleed valve.

Engine operating parameters such as fuel flow, stator vane position, bleed valve position, and others are computed from this data and applied as appropriate.

Control computers are programmed to make sure the fuel bleed valve is no more than 20 percent open by ignition time, or else the whole count will be cut off automatically.

Depending on the type of bleed valve, you can use either a screwdriver or a radiator key (available at hardware or plumbing supply stores) to open the valve.