ash content

It is of low calorific value and high ash content.

The plant has also started to use washed coal, due to its lower ash content.

Such coal often has ash content averaging 40 per cent.

It is possible to determine ash content from some US manufacturers.

In general, as the extraction rate of the flour increases, so do both the protein and the ash content.

The high ash content in India's coal affects the thermal power plant's potential emissions.

The powder has good mechanical strength, low ash content and is eco friendly.

Jellico coal, as it came to be known, burned relatively slowly and had a low ash content.

Many dams in the US have been constructed with high fly ash contents.

Elemental ash content of each substance, derived from mass-spectrometer analysis, is attached.

The plant's high ash content has led to its use for manure, and its conversion into compost.

The main objective is to decrease the ash content and improve the maceral composition of the final clean product.

The station was built specifically to burn the semi bituminous coal with its high ash content.

The close to zero ash content of forest biomass significantly reduces dead load in transportation and processing.

The following table shows some typical examples of how protein and ash content relate to each other in wheat flour:

The coal carried in the locomotive's tender could not sustain the 420 km long journey, due to the high ash content.

Important quality parameters for pulp not directly related to the fibres are brightness, dirt levels, viscosity and ash content.

Niger's known coal reserves, with low energy and high ash content, cannot compete against higher quality coal on the world market.

He determined that the excrement's chemical composition was similar to that of the feed, the only major exception being the ash content.

Measurements of the electrical conductivity are used to determine the quality of honey in terms of ash content.

Mining and utilisation of the coal is expected to be constrained by its depth, high ash content, and structural complexity.

However, as the extraction rate approaches 100% (whole meal), the protein content drops slightly, while the ash content continues to rise.

If the identity of the product after heating is known, then the ceramic yield can be found from analysis of the ash content (see discussion below).

Low ash contents.

Ash content of coal is the non-combustible residue left after coal is burnt.