adjusting screw

Had to do even brackets for mirrors, and adjusting screws.

There should be an adjusting screw near the bottom on each side that can be turned to slightly raise or lower these rollers.

These are in the base of the door, and each can be raised or lowered by turning an adjusting screw accessible along the door's lower edge.

The whole is furnished with levels and adjusting screws and mounted on a tripod.

The adjusting screw was locked by a locknut.

If the door wobbles or seems to drag along the bottom, raise it by equally turning both adjusting screws clockwise.

To remove rollers from some doors, it is only necessary to loosen one or more obvious screws, including the adjusting screw.

The scratchplate partly covers the pickup mounting rings but has been cut to allow full access to the adjusting screws.

Alternatively, extend the roller that is farthest from the gap by turning its adjusting screw clockwise.

Carefully, Chester pried off the tiny protective cap, exposing the factory-set adjusting screw.

The clamp has an adjusting screw to tighten onto the part and a lifting ring to attach a hoist cable.

Check that the unit is level, and adjust it, if necessary, by turning the appropriate adjusting screws or sliding additional sturdy wood blocks underneath.

To adjust, the operator removes half the amount the bubble has run off using the adjusting screw, then re-level, test and refine the adjustment.

Hence aiming of the barrel was done by adjusting the length of the guys via adjusting screws.

The lower caliper in the image has an adjusting screw that permits it to be carefully adjusted without removal of the tool from the workpiece.

On some doors, the adjusting screws are at the ends of the door; on others, the screws are installed along the inside face.

If it feels tight, turn both adjusting screws counterclockwise to retract the rollers an equal amount until the door slides more smoothly.

The small weight ' was adjusted with the adjusting screw, and the process repeated until the pendulum had the same period when swung from each pivot.

Both types of lopper generally have a sprung adjusting screw at the fulcrum, which can be used to tighten the blades as they loosen in use.

Finally, the compensating pump adjustment will be improved by replacing the existing adjusting clamp with an adjusting screw and jam nut.

The camshaft operated the valves by rockers with rollers on their camshaft ends and adjusting screws at the other.

If the problem persists, or if flushing is inadequate even when the adjusting screw is turned fully counterclockwise, replace the valve assembly.

The adjusting screws allow the die to be compressed or expanded to accommodate slight variations in size, due to material, manufacture, or die sharpness.

On tankless toilets with pressurized flush valves, turn the brass adjusting screw in the control stop, the fitting that joins the valve to the supply plumbing.

Two young men tended the device with diligence, trimming the twenty-five wicks, prodding the fire, adjusting screws and levers which in turn controlled the mirrors and lenses.