absolute pressure

Where p simply denotes the absolute pressure in the observed system.

However, the boiling point of water is dependent on absolute pressure inside the pipe.

The law can also be stated in a slightly different manner, that the product of absolute pressure and volume is always constant.

Absolute pressures (psia) must be used for gas rather than simply differential pressure.

The absolute pressure in the tire is essentially unchanged.

This is being solved by the extension of the reference volumes used even in absolute pressure sensors.

The air density is calculated using the absolute pressure and temperature in the intake manifold.

For example, the absolute pressure compared to vacuum is:

Vacuum is the difference between the absolute pressures of the intake manifold and atmosphere.

That set absolute pressure is usually 100 kPa.

Base conditions, also known as standard conditions, consist of a specified absolute pressure and temperature.

Boost pressure is relative to absolute pressure - as one increases or decreases, so does the other.

Boost sensors or gauges measure the amount of pressure above a set absolute pressure.

The atmospheric pressure decreases with altitude, and this has an effect on the absolute pressure of the diving environment.

"Below atmospheric" means that the absolute pressure is equal to the current atmospheric pressure.

Similar to the -D1A but with a lower power rating, different turbocharger spring rate and a variable absolute pressure controller.

The engine fundamentally responds to air mass, not vacuum, and absolute pressure is necessary to calculate mass.

An absolute pressure measurement is one that is referred to absolute vacuum.

To produce an absolute pressure sensor the manufacturer will seal a high vacuum behind the sensing diaphragm.

Modern high-pressure thermal cracking operates at absolute pressures of about 7,000 kPa.

Typically, pressurization of a flask takes 10 seconds, and is monitored by an internal absolute pressure sensor.

When these systems are employed the maximum absolute pressure at the inlet valve is typically around 2 times atmospheric pressure or more.

Absolute pressure sensor This sensor measures the pressure relative to perfect vacuum.

Vacuum is primarily measured by its absolute pressure, but a complete characterization requires further parameters, such as temperature and chemical composition.

Boyle found out that in a closed system, the absolute pressure and volume of a gas are inversely proportional, if the temperature is kept constant.